+86 158 9882 2106 [email protected]

Mining Diesel Generator Sets

Prime and standby power from 20 to 2,000 kVA — built on Cummins, Perkins and Volvo platforms, configured for site altitude, ambient temperature and underground duty.

Choose by Duty

Prime Power (PRP)

Continuous base-load supply for off-grid mines, typically 6,000–8,000 hours a year. Rated to ISO 8528 PRP with 10% overload available for one hour in twelve. This is the correct rating for ventilation fans, pumps, dewatering and processing loads.

Standby Power (ESP)

Back-up supply against grid failure or for peak shaving, rated to ISO 8528 ESP for variable load and limited annual hours. Supplied ATS-ready with auto start, mains failure detection and load transfer logic.

Choose by Installation

Open Skid

Fabricated steel baseframe with anti-vibration mounts and sub-base fuel tank. Lowest cost and easiest to service where a dedicated plant room already exists.

Sound-Attenuated Canopy

Weatherproof enclosure at 75 dB(A) or lower at 7 m, with lockable access doors, integrated tank and lifting points. Standard for surface camps and populated sites.

Containerised

20 ft modules for 500–1,000 kVA and 40 ft modules for 1,000–2,500 kVA, factory assembled and tested, with bunded tank, cable entry and parallel-ready switchgear.

Trailer-Mounted

Mobile units for exploration camps, development headings and standby duty that moves with the works. Road-towable chassis with lights, brakes and 8–12 hour integral tank.

Typical Range by Application

Indicative configurations — final rating is confirmed against site altitude, ambient temperature and load profile
ApplicationPrime outputTypical configuration
Exploration camp & small decline20–200 kVATrailer or skid, 8–12 h integral tank, canopy optional
Development headings & auxiliary fans200–500 kVACanopy, 1,000 l sub-base tank, dual-stage air filtration
Underground substation500–1,000 kVALow-profile skid or 20 ft container, flame arrestor, gas interlock
Surface plant & mill1,000–2,000 kVA40 ft container or open set, parallel-ready, SCADA interface

Underground Mining Specification

  • Low-profile baseframe for transport through declines and shafts
  • Exhaust flame arrestor and spark arrestor options
  • Gas detection interlock with automatic shutdown
  • Dual-stage air filtration for dust-laden ventilation air
  • Oversized radiator rated for 45–50 °C ambient
  • 24 V dual battery starting with remote start / stop

What We Need to Quote

  • Prime or standby rating, plus the load profile and largest motor start
  • Site altitude, ambient temperature and humidity
  • Installation: open skid, canopy, container or trailer
  • Voltage, frequency and phase; single unit or parallel operation
  • Fuel autonomy required between refuelling
  • Compliance target: CE, EPA Tier 4 Final, EU Stage V or MSHA options

Need a power configuration for your mine?

Send us the load list, site altitude and installation constraints — we will size the set and quote the package.

Request a Quote